1. Prevent the conveyor belt from being blocked by racks, pillars, or block materials, and prevent it from being damaged or torn. If the conveyor belt deviates during pregnancy, the problem should be invented and changed as soon as possible; 3. Prevent the rollers from being surrounded by materials, causing ineffective reversal, and prevent material leakage from getting stuck between the drum and the tape. Transport carefully. 4. Lubricate the moving parts of the conveyor belt, but do not let it be contaminated with oil; If the conveyor belt is partially crushed, artificial cotton should be used to repair it in a timely manner to prevent it from expanding and causing unnecessary poverty; 6. Prevent the transportation from starting with a load.
Detailed topics to be addressed in recuperation:
During transportation and storage, the conveyor belt should be kept clean and protected from direct sunlight or rain and snow, to prevent contact with substances such as acids, alkalis, oils, and organic solvents, and to isolate heating devices from one meter away. During storage, the temperature in the warehouse should be maintained between 18-40 ℃, and the relative humidity should be maintained between 50-80%; During storage, the conveyor belt must be arranged in rolls and not folded. During the arrangement period, it should be flipped once every quarter; Conveyor belts with different specifications and layers should not be used together, and it is best to use adhesive bonding for discussion; The model, structure, specifications, and number of layers of the conveyor belt should be selected fairly based on the usage conditions; The running speed of the conveyor belt should not exceed 2.5 meters per second, and materials with large block size and high wear and tear, as well as the use of sturdy unloading devices, should be handled at a low speed. The relationship between the diameter of the transmission drum of the conveyor and the fabric layer of the conveyor belt, the matching of the transmission drum and the reversing drum, and the requirements for the groove angle of the idler should be selected fairly according to the planning regulations of the conveyor. The feeding direction should follow the running direction of the conveyor belt. To reduce the impact on the conveyor belt when materials fall, a chute should be used to minimize the separation of material falling; The receiving section of the conveyor belt should tighten the spacing between the rollers and adopt buffer rollers to prevent material leakage. A soft and moderate material blocking plate should be used to prevent the blocking plate from being too hard and scratching the surface of the conveyor belt.
This article is from:
www.e-testing.net.cn